Digital Ring Electrode (Thin, Rigid Steel Thread)

This Digital Ring Electrode is made for NCS-examinations (nerve-conduction studies) and can be used to record or apply an electrical stimulation at the desired location on fingers or toes. It can also be used for both EMG and EP applications.

This Digital Ring Electrode model comes with a thin steel and rigid fastening mechanism. It is equipped with two steel stimulation electrodes, one for the positive (+ anode) and another for the negative (- cathode) pole. Digital ring electrodes come pre-assembled with a 150cm cable (shielded wire) and terminate in two DIN 1.5mm touch-proof (TP) sockets (female connector). It has a lifetime of 300 uses when used correctly. The loop of the stimulation electrodes is 24mm in length and 1.0mm in diameter.

When using the digital ring electrode in its recommended fields of application, clean the patient's skin with a damp cotton ball before fastening to either the subject's fingers or toes. After each use, clean the electrode with a damp cloth and mild detergent.

One Digital Ring Electrode (Thin, Rigid Steel Thread) version per pack.

Technical Specifications

• Electrode material: Thin Rigid Steel Thread (1.0mm diameter)
• Loop length: 24mm
• Cable length: 150cm
• Connectors: 2 x DIN 1.5mm touch-proof (TP) sockets (female connectors)
• Lifetime: Semi-disposable (300 cycles)

Application Note

1. Prep the subject's skin at the desired stimulation/recording location.
2. Open the fastener/velcro strap of the electrode.
3. Fix the digital ring electrode at the desired location (toe or finger).
4. Connect the DIN 1.5mm touch-proof (TP) connectors to the electrical stimulator or biosignal acquisition system.
5. Check the signal quality. Apply a minimal amount of electrolyte gel if the signal quality is not satisfactory.
6. After use, remove the digital ring electrode and clean the electrode with a mild detergent or disinfectant.

Note: Do not sterilize digital ring electrodes!