No Additional PayPal Fees
Prices Lower than our Regular Pricelist Prices
Fast Support Reply


View as Grid List
Sort by
Display per page

Active Electrode for Biosemi Systems

Active Sensor Set with a 68-pole fine-pitch connector. 32*Pin-Type sensor with sintered Ag/AgCl tip and integrated low-noise CMOS pre-amplifier. Two-wire design. Standard cable length is 140cm. Electrode Sets are available in standard 10-20 label fashion or in the extended ABC label fashion.

Biosemi Active Electrode Repair Order

NEUROSPEC AG offers repairs/replacements for the Active Electrodes manufactured by Biosemi BV as below specified.

Please add each set separately to your basket (outside the standard 12 months warranty from date of purchase).

V-Shaped Adhesive Electrode Pads

Foam pads with adhesive backing. Use with E21 Disk Electrode as an alternative to the E5 Ear Electrodes or virtually any additional electrode placement (i.e. eye, ECG, EMG etc.). 100 pieces per pack.

Electrode Impedance Checker

The Electrode Impedance Checker is suitable for measuring electrode contact impedance for all surface biopotential measurements, including those for ECG, EEG, EGG, EMG, EOG, Bioimpedance and Impedance Cardiography. It allows simultaneous connection of up to three electrode leads, for quick impedance checking between any two electrodes in the three connected leads Active (Vin+), Reference (Vin-), and Ground (GND).

Impedance Measurement Device

Impedance Measurement Device made by NEUROWERK to measure the impedance of EEG and EMG electrodes.
€198.00 €142.00
29 % off

EEG Photic LED Flash with Software

LED photic stimulator with articulating arm, control software, cabling. Ideal for photic activation during EEG studies, this LED photic stimulator combines the brightness of a Xenon flash with the utility and ease of use of an LED device. The device has an equivalent lamp shape and brightness to the Grass PS33 whilst being smaller, lighter and more energy efficient by utilizing bright light LED technology. The disadvantages of Xenon tube lamps are well known. They are heavy mains powered devices that are generally very expensive, whilst posing a potential safety hazard to the patient and operator. Package includes: Photic LED Flash, USB connection cable, cable clamp, software to run the photic, color filter pack, trigger cable.

Electrode Rack

Specially designed electrode cable rack for hanging electrode sets to dry after cleaning.

Disposable Ag/AgCl Cup Electrodes

Disposable 10mm Cup Electrodes is an excellent alternative to the traditional Ag/AgCl electrodes. These low cost disposable electrodes allow recording for EPs and PSGs. The electrode material is made of plastic with a thin Ag/AgCl layer (very lightweight electrode). 500 pieces per box.

Water Resistant EEG Labels

Water Resistant EEG Labels for electrodes and cap holders, available as 10-20, ABCDEFGH or EXG style. 1 sheet per pack (labels can be peeled off). Labels are 100% water resistant.

Dry Ag/AgCl Reusable Electrodes (EL120)

Dry Ag/AgCl (Silver-silver chloride) electrodes provide accurate and clear transmission of surface biopotentials and are useful for recording all surface biopotentials on animals and human EEG. Can be used dry or with gel. 10 electrodes per pack. Please add any amount of LEAD120 cables in order to have enough channels for your acquisition.