MP35/MP36R Trigger Cable

This MP35/MP36R Trigger Cable is used for sending TTL trigger markers from your stimulation presentation computer (running Presentation, E-Prime, PsychoPy, SuperLab etc.) to the I/O Port on the back of the MP35 or MP36R from BIOPAC Systems Inc. The MP35/MP36R trigger cable comes configured with D-Sub 25 (male) to D-Sub 25 (female) connectors.

This MP35/MP36R Trigger Cable replaces the STP35A/STP35B entirely and should not be used in conjunction with an STP35A or STP35B trigger adaptor from BIOPAC Systems Inc.

The length of the MP35/MP35R trigger cable is 1m. One MP36/MP36R trigger cable per pack.

Note: The MP35/MP36R Trigger Cable must only be used with an MP35 or MP36R system from BIOPAC Systems Inc. Using the MP35/MP36R trigger cable with other biosignal acquisitions systems may lead to system failures or even damaging the biosignal acquisition system. Contact us for further information.

Features

• Provides high-quality and high-speed data transfer of TTL trigger markers
• Molded assembly with fully encapsulated hoods and thumb screws
• All lines wired according to the MP35 and MP36R (BIOPAC Systems Inc.) trigger cable configuration

Application Note

Connect the D-Sub 25 (male) connector to the stimulus presentation side (e.g., LPT Port or MMBT-S) and the D-Sub 25 (female) connector to the I/O Port on the rear of the MP35 or MP36R from BIOPAC Systems Inc.

Technical Specifications

• Cable Length: 1m
• Connectors: D-Sub 25 (male) to D-Sub 25 (female)
• Hardware Compatability:
  • MP35, BIOPAC Systems Inc.
  • MP36R, BIOPAC Systems Inc.
  • MMBT-S Trigger Interface Box, NEUROSPEC AG
  • for other systems, please enquire (Contact Us)

Cable Pinout

This MP35/MP36R trigger cable for the MP35 and MP36R systems from BIOPAC Systems Inc. has the following pinout: