Skip to the beginning of the images gallery

D-Sub 25 to Single BNC Trigger Cable

$140.30

SKU

NS-7938

D-Sub 25 (male) to single BNC (male) Trigger Cable, 1-bit trigger marker (available on pin 2 / first bit), cable length: 10cm.

Details

This trigger cable transmits a 1-bit trigger marker. The output of the trigger cable is usually TTL (transistor-transistor logic), meaning 5 V for High and 0 V for Low. However, other voltage levels or an AC signal can be transferred with this trigger cable. One end of the cable is a D-Sub 25 connector (male), connected through to a single BNC connector. The cable transmits 1-bit trigger marker information to pin 2 (1st bit of a standard TTL trigger layout cable). Hence, for a standard LPT configuration, every odd trigger marker (1, 3, 5, 7, ... 255) is transferred to the receiving end connected to the BNC connector. Pin 25 is used as ground (GND). The pinout can be adjusted upon request. The cable's length is 10cm. Cable color might vary.

Technical Specifications

Cable Length: 10cm (can be adjust upon request)
Connectors: D-Sub 25 (male) to BNC (male)
Hardware Compatability:
- MMBT-S Trigger Interface Box, NEUROSPEC AG
- for other systems, please enquire (Contact Us)

Cable Pinout

This trigger cable has the following pinout:

Pin Connector A (D-Sub 25, male)	Pin Connector B (BNC, male)	Definition / Notes
1	N/C	N/C (not connected)
2	Pin (Center Contact)	Digital Trigger 1 TTL (0-5V)
3-24	N/C	N/C (not connected)
25	Shield (Outer Contact)	GND (Ground)